Mazda3 Forums banner

I dun goofed

2K views 5 replies 4 participants last post by  MorrisGray 
#1 ·
Replaced the PCV valve on my 2006 2.3L 3S. The one way down deep in there, where you have to take off the manifold, throttle body, etc.

The operation itself goes fairly smooth, and the valve was pretty gummed-up.

I'm real careful with re-assembly, new gaskets, new o-rings, I'm sure to connect all wires and use proper torques.

I go to start...turn ignition to ON position...and no crank. Starter doesn't turn over.

My dashboard lights up, my battery has 12V, my relays work. Everything worked fine prior to this procedure.

Any ideas as to why I now have no crank.

I'm turning my attention to the starter, maybe working in the engine bay inadvertently weakened a ground wire connection?

Thanks,
AG
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top