Every warning light on the dash is on. To give a little history it’s a 2010 Mazda 3S with 140,000 miles I replaced all four wheel bearings and ABS sensors there were no previews dash lights on before I did this. Now when driving the speedometer will quit working and the power steering will quit working and all the lights appear after being reset. Any ideas?
The parts I ordered from Detroit Axle, I’m very confident that I’ve installed the hub assembly and wheel bearings correct. This is not my 1st go around with wheel bearings but this is my 1st Mazda. I’m just really confused about it throwing so many codes.
Just to update today I’ve changed engine oil and transmission fluid also. I use mobile 1 synthetic 5w-30 and mobile 1 Synthetic gear oil 75-90. I’ve taken the battery out and made
Sure it was fully charged cleared all codes. While driving I got to about 35-40 mph then all warning lights popped back on also lost the speedometer
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Mazda3 Forums
4.3M posts
249.4K members
Since 2000
A forum community dedicated to Mazda 3 and all Mazda vehicle owners and enthusiasts. Come join the discussion about MazdaSpeed performance, modifications, classifieds, troubleshooting, maintenance, and more!